Epoxy Adhesive-50ml Alu.Tube
4 minutes rapid EPOXY Adhesives consist of two components. Resin and hardener are forced to mix. It hardens rapidly. After full hardening, it is waterproof, endures 320℉,resistant to most weak chemicals, paintable and insulation.
代碼 NE03337
人氣 1128
4 minutes rapid EPOXY Adhesives consist of two components. Resin and hardener are forced to mix. It hardens rapidly. After full hardening, it is waterproof, endures 320℉,resistant to most weak chemicals, paintable and insulation.
APPLICATIONS:
Metal, Glass, Stone, Ceramic, Fiberglass, Fiber carbon wood, rigid leather, rigid plastic(PVC,ABS,PS).
Rapid repair for crack of wall, marble leakage, electrical appliance, craft, adornment, model, fishing tackle, toy, part of car, sport appliance etc.
UNSUITABLE:【PE, PP, Fluororesin, Silicone Plastic, foam】
DIRECTIONS FOR USE:
1.Roughen the surfaces to be joined or repaired with sandpaper. Ensure surfaces are clean & dry free from dirt, oil moisture, rust.
2. Remove caps. Pierce the end of tubes with points on caps. Be careful to avoid spilling of adhesive when piercing.
3. Squeeze equal amount of Resin & Hardener onto a clean surface. Mix thoroughly.【Mix ratio=1:1 Wrong ratio or unequal mixing may result in bad hardness.】
4. Finish the whole operation within 3 minutes. Solidify in 4 minutes. Full bond strength is reached after 24 hours.【When the temperature is below 10℃, the hardening time is longer.】
CAUTION:
Irritation for eyes, skin respiratory system. Previous protection is recommended. For skin contact, wipe off contamination and wash thoroughly with soap and warm water. In case of eye contact, rinse with plenty of warm water and get prompt medical attention. If swallowed, seek the physician.
【KEEP OUT OF REACH OF CHILDREN】
Improper use may damage the surface. Be sure to test on an inconspicuous area in advance.
Be sure to dump the waste in a permitted environment under the law.
四分鐘AB膠，是一種AB兩劑強迫混合，快速硬化黏合劑，操作時間急迫。完全硬化後可防水。耐溫320℉，且抗大多數化學侵蝕，絕緣（不導電），可上漆。
用途說明:
金屬、玻璃、石材、陶瓷、碳纖維、玻璃纖維、木材、硬質皮革、硬質塑膠(PVC,ABS,PS)。
居屋水泥裂縫、磁磚、大理石掉落修補黏合、電器製品、藝品、裝飾品、模型、釣具、玩具、汽車零件、運動器材…等，居可快速修復黏合。
不適用材質:【聚乙稀、聚丙稀、氟素樹脂、矽膠、泡棉】
使用方式:
1.將欲修補黏著的表面用砂紙磨予粗糙，確保表面潔淨乾燥。
2.旋開蓋子，用蓋子頂端的針狀物將金屬封口刺穿，不要緊捏瓶身，以免膠水大量溢出。
3.擠出酮等量的A、B兩劑，均勻攪拌混合。【混合比例1:1，誤差大或混合不均勻會造成硬化不良。】
4.請在3分鐘之內完成黏合固定作業。4分鐘硬化，最佳黏合強度須經24小時。【氣溫低於10℃以下則硬化時間較長】
注意事項:
請戴護具施工，誤觸皮膚時，請用肥皂和清水搓揉剝離或用(乙醇)酒精擦拭即可，誤入眼睛時不可搓揉，立刻用大量清水沖洗數分，且就醫診治，若誤食立刻送醫治療。【存放兒童取扱不到的地方】不當的使用，可能會造成物品受損，務必事先測試接著物材料，測試滿意才使用本產品進行施工黏合。本產品廢棄處理方式，須在政府核可廢棄物處理設施處理。
主要成分:環氧樹脂、聚醯樹脂。